Digital DC0-100V 20A Voltmeter Ammeter Red Green LED Dual Display For 12v 24v Car Voltage Current Monitor No Need External Shunt

Get Digital DC0-100V 20A Voltmeter Ammeter Red Green LED Dual Display For 12v 24v Car Voltage Current Monitor No Need External Shunt

Technical Parameters:

Supply voltage (non-isolated meter): DC3.5 ~ 30V (wide range),

Note: The maximum input voltage can not exceed 30V, otherwise it will be burned

Isolation meter (isolated power supply meter): DC8-18V

Operating Current: <20mA

Display: 0.39 "LED, voltage - red, Current - Green

Dimensions: 70 × 40 × 30 mm

Installation hole: 68 × 38 mm

Measurement rate: ≥500mS / times

Accuracy: 1% (± 1 word)

Extreme working conditions:

Min. supply voltage: + 3.5V

Max. supply voltage: + 30V

Working temperature: -10 ~ + 65

Operating Humidity: 10 ~ 80% (non-condensing)

Working pressure: 80 ~ 106kPa

Sunlight: no direct exposure

Power meter: Two line socket

Thin - Black Line: Header supply Negative

Thin - Red line: Header supply positive

(Note: voltage between red and black lines can't exceed 30V)

Test side: Three line socket

COM: Test Common

V +: Test positive voltage input

A +: Test "positive" current input; check the drawing before install or it will burn. Because the header by co-design, which means the earth wire of test and power supply is interlinked,so only can be connected to between the negative power supply and the negative of the tested device

(We recommend to link the yellow line and the black lines together, to prevent outside interference caused by digital ammeter flashing)

Package included:

1 x Digital Voltmeter Ammeter

Digital DC0-100V 20A Voltmeter Ammeter Red Green LED Dual Display For 12v 24v Car Voltage Current Monitor No Need External Shunt See detail

3pcs BME280 Digital Sensor Temperature Humidity Atmospheric Pressure Sensor Module

Get 3pcs BME280 Digital Sensor Temperature Humidity Atmospheric Pressure Sensor Module Features: BME280, the precision sensor from , is soldered onto PCB. Not only the pressure and the temperature, this sensor can measure humidity. It uses both I2C and SPI (supports 3-, 4-wire SPI) interface High precision, ultra-low power consumption pressure sensors, can be applied to mobile devices. Specifications: Operating voltage: 3.3 V Pressure ranges: 300-1100 hPa (equivalent to + 9000 ...- 500 m above / below sea level) Relative accuracy: ± 12 hPa (equivalent to ± 1 m 950 ~ 1050hPa @ 25 ° C) Absolute precision type: ± 1 hPa (950 ... 1050 hPa, 0 ~+ 40 ° C) Offset temperature coefficient: 1.5 Pa / K, equiv. At 12.6 cm / K (25 ~ 40 ° C at 900 hPa) Temperature range: -40- + 85 ° C PCB Size: 15.5 x 11.5 mm Package Included: 3 x BMP280 Digital Sensor Module 3 x 6P Pin 3pcs BME280 Digital Sensor Temperature Humidity Atmospheric Pre...

TTGO 0.96 Inch ESP32 V2.0 OLED WiFi Module + Bluetooth Double ESP-32 et OLED 4 MB For Arduino

Get TTGO 0.96 Inch ESP32 V2.0 OLED WiFi Module + Bluetooth Double ESP-32 et OLED 4 MB For Arduino Features: 1. Main control chip uses ESP32, Tensilica dual core processor, clocked at 240 MHz, computing capacity of up to 600 DMIPS, 520 SRAM, 802.11 KB chip b/g/n HT40 Wi-Fi transceiver, baseband, and LWIP protocol stack, Bluetooth (Bluetooth dual-mode integrated traditional and BLE low-power Bluetooth) 2. Onboard 4 M bytes (32 M bit) , flash, and Wi-Fi antennas 3. 0.96-inch White OLED display 4. Lithium battery charging circuit and interface 5. CP2102 USB to serial chip, perfect support for Arduino development Package includes: 1 x ESP32 OLED V2.0 1 x line 2 x pin TTGO 0.96 Inch ESP32 V2.0 OLED WiFi Module + Bluetooth Double ESP-32 et OLED 4 MB For Arduino See detail

No-hole Sensor Cabinet Lock Electronic Hidden Home Furniture Door Drawers Lock

Get No-hole Sensor Cabinet Lock Electronic Hidden Home Furniture Door Drawers Lock Features: ● It is suitable only for a wooden door, especially for a drawer, locker, cabinet, sliding door. ● No need to drill holes, no damage to your cabinet. ● Auto return and auto lock function, easy operation. ● Stainless steel latch and ABS plastic case, durable and anti-corrosion. Specifications: - Material: stainless steel - Type: 1 key/2keys - Lock case material: ABS plastic - Accept the thickness of the cabinet door or wardorbe: within 50 mm. - Only suitable for wooden door - Power supply: 4x AA batteries. Package Included: 1 x No-hole Cabinet Lock 1 x Key(1 key/2keys optional) 1 Set Accessory Details Pictures: No-hole Sensor Cabinet Lock Electronic Hidden Home Furniture Door Drawers Lock See detail

Yuna Maslova

Search This Blog